MTS Systems Series TBF-R User Manual download pdf (Page 31)

4 Set-up

4.1 Connection

When the servo amplifier is used together with one of our motors, the connection does not

cause any problems. In 3.4 you will find the connection diagrams. Connect the motor power

contacts U, V, W, earth and shield as described there. The resolvers are also connected

as described in 3.4.

When using an auxiliary drive together with the servo amplifier TBF, we offer to

work out the correct connection diagram for you.

4.2 Presetting

Prior to set-up please read the chapters 1, 2, and 3.

For connecting the power amplifier and the motor sensors, the specifications

given in the connection diagrams 3.40 have to be strictly observed! Connecting

the motor "in any way" and to exchange two phase in case of wrong directional

run is not useful! We therefore offer to first check the capability of auxiliary

drives in-house.

• Connect the power amplifier to the motor (see 3.4 Figure 5/Figure 6)

• Connect the sensors of the motor (resolver) to the servo amplifier (see 3.4 Figure 5/

Figure 6)

• Connect the amplifier with the power supply (see 3.4 Figure 5/Figure 6)

• The factory configures the servo amplifier so our motors will reach 3000 rpm with 10V

setpoint default.

If you need other speed values or if this motor/amplifier combination is set up

for the first time, please proceed as follows.

Input potentiometer P1 five turns from left stop

Pulse current potentiometer P2 five turns from left stop

Amplification P3 Shipped adjustment by two turns

to the left

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 50 51

No comments

MTS Systems Series TBF-R User Manual Page 31